Chevroletforum - chevroletforum.com - ChevroletForum
General Information:
Latest News:
Steering seems to bind just off center. 27 Aug 2013 | 12:37 pm
1991 G20. All of a sudden the steering was hard, intermittent assist and it didn't like to return to center on it's own. I had a '95 van before this one, it died of frame rot but I saved some parts, ...
2002 chevy 1500 V-8, extnded cab 27 Aug 2013 | 11:01 am
Originally, the vehicle would run 2-3 minutes, then die. MIL: off. After replacing the fuel filter, the engine would run longer, but the scanner showed engine timing to be as high as 35 degrees advanc...
Any Suggestions? 27 Aug 2013 | 08:30 am
Ok I am now "legally" new to the road i have a 1974 Chevy custom classic c10 longbed truck, runs strong with a 350 V8 needs new filters and belts but currently taking care of that i need some suggesti...
silverado icm high voltage 27 Aug 2013 | 06:23 am
I have a 2000 Silverado Ithas the 4.3l v6 1500 4x4 I have put over $2k in new parts in it sensors etc. it will turn over and act like it is going to start then nothing .sometimes it wll start and run\...
Possibly buying an 04 z71 27 Aug 2013 | 05:09 am
Hey im new to the forum and am about to possibly trade my 07 tacoma in for a 04 silverado z71...the silverado has 127,519 miles on it and can be seen in this link 2004 Chevrolet Silverado 1500 Z71 4X4...
Carb isn't getting any gas 27 Aug 2013 | 03:40 am
Hello, I'm working on an old 1984 350 engine and cannot get it started. The fuel pump is new, fuel line is new, fuel filter is new and when checking to see if any fuel is getting to the carburetor, i...
ac compressor replacement 27 Aug 2013 | 02:52 am
Have a 94' Cap. Classic Wagon, 5.7L. ac compressor clutch bearing gone. Compressor good, bearing and clutch gone. What other models have the same compressor as I'm thinking just swapping the compresso...
1994 Silverado Shifts Hard 27 Aug 2013 | 01:50 am
I have a 1994 Silverado with the 4L60E tranny. It was just rebuilt and is not shifting correctly. It shifts at higher rpms than it should in all gears, but from first to second is really hard. After ...
Parts ID in Bottom End of SBC 27 Aug 2013 | 01:24 am
New to the forum. I bought my '79 C3 Corvette back in April and the guy I brought it from knew nothing about it other than the guy HE bought it from would take it to the drags. This weekend I pulled ...
1985 k2500 27 Aug 2013 | 12:59 am
Hello, I am looking at purchasing a 1985 K2500 and dropping in a 6.6 Diesel. My question, what transfer case would I need to keep the solid axle? Thank you.
